Nylon 6
Nylon 6 also known as Polyamide, is characterized by a combination of high strength, toughness and abrasion resistance and is ranked as an Engineering Plastic. This is because of its unique balance of mechanical, thermal, frictional and chemical properties. Nylon behaves in a predictable, reproducible manner under load and in known environments. Engineers and designers are looking to nylon as a substitute for design material such as phosphor bronze, gunmetal, cast iron, copper, aluminium and the entire family of steels.

Nylon is well accepted for several engineering applications. It is tough and hard, with good mechanical properties, high resistance to abrasion and impact and low friction properties.

Extruded Rods:
3mm to 9" diameter in standard lengths of 300mm, 1000mm, 4 ft., bigger cut to size & roll lengths.

Extruded Square Rods:
3/4" to 3" square (across flat) in standard 300mm, 1000mm, 4 ft., and non-standard lengths.

Extruded Sheets & Flat Strips:
0.2mm to 70mm thickness in width 300mm to 1000mm in roll length & ct to length up to 3000mm

Nylon 66
Nylon 66 material bears higher mechanical strength, stiffness, hardness, toughness, heat and excellent wear resistance than Nylon "6". Nylon 66 has the highest melting point & it is the strongest and the most rigid of all unmodified nylons. It also has good sliding properties; better creep resistance but its impact strength and mechanical damping ability are reduced.

This product also has outstanding resistance to alkalies and organic materials, as well as good electrical insulating characteristics.

Modified & specialty grades are offered for defined industrial applications.

Rods: 6mm to 200mm diameter in 300mm, 1000mm & bigger lengths.
Flats: Small sized sheets & flats are produced against specific orders only.
Tubes & Hollow Rods can be offered on request subject to quantity.

Polyacetal (Polyoxymethylene - POM)
Polyacetal (Polyoxymethylene - POM) is a widely used crystalline engineering thermoplastic popularly known as Delrin® which is a homopolymer Polyacetal which exhibits slightly different characteristics in copolymer grades. Polyacetal is characterized as having an excellent combination of physical properties that makes it suitable for numerous industrial applications.

Polyacetal has the following characteristics:

Polyacetal is used in many static & dynamic industrial applications replacing materials like; steel brass, bronze, copper and aluminium. Polyacetal have improved part life because of; better wear, more chemical and corrosion resistance. These materials reduce factory noise and will reduce or eliminate the need for lubricants.

Polyacetal can be used in applications such as; Gears, Bushings, Bearings, Rollers, Timing Screws, manifolds, Valves and Valve Bodies, Washers, Wear Pads, and many industrial machine parts.

Polyacetal Rods:
1/4" to 8" diameter in standard lengths of 300mm, up to 5 ft.

Polyacetal Sheets & Flat Strips:
6mm to 80mm in standard widths up to 300mm, 600mm, 1000mm in lengths of 1000mm, 4 ft., 2000mm.

  Polyacetal Square Rods:
3/4" to 3" square (across flat) in 300mm, 1000mm & 4 ft. lengths.